Before you start the oven repair, you must verify the serviceability of the electric cable. If he is in perfect order, then the oven itself is faulty.
ремонт духовок Bosch (Бош)
ремонт духовок Candy (Канди)
ремонт духовок Daewoo (Деу)
ремонт духовок Electrolux
ремонт духовок Gorenje (Горенье)
ремонт духовок Hansa (Ханса)
ремонт духовок Indesit
ремонт духовок Kaiser (Кайзер)
ремонт духовок LG
ремонт духовок https://servicecenter.kiev.ua/remont-duhovogo-shkafa-kiev
The most common causes of problems in this technique :
control system crash ;
breakdown of mechanical timers, mode switches ;
malfunction of the mechanical thermostat ;
failure of fans ;
breakdown of the tubular power heater (TEN).
Whatever the reason for the breakdown of the oven, instruct repair of household appliances still better for professionals, because their own intervention often leads to even more serious malfunctions.
Control system crash
In case of an electronics failure, the system will independently issue an error code on the display, that is, it will show what part needs to be replaced. Nothing needs to be repaired here, you only need to purchase a replacement for a failed element.
Breakdown of mechanical timers, mode switches
The breakdown of these elements in most cases requires their replacement, however, you can try to clean them with a weak solution of ammonia on your own. Corrosion from devices should be removed with primer.
Malfunction of a mechanical thermostat
The device is not subject to repair and is mandatory replaced with a new one.
Failure of fans
Over time, fan of blowing and grilling lose the ability to create a wide air flow. In case of serviceability of the engine itself, you just need to clean the rotating element (squeal) of dust, dirt and fat using the same ammonia. If the fan is completely out of order, then the only solution to the problem is to replace the ventilation unit. https://servicecenter.kiev.ua/
Forklift Heater (TEN)
The heating element of the oven always works at full power. Checking if it works properly is easy. It is enough to turn on the maximum temperature in the oven and check its compliance with the readings of the pyrometer - a device for non-contact measurement of body temperature. It will not only show the actual temperature in the oven, but also the uniformity of its distribution in area. In the absence of a pyrometer, you can measure the temperature in the oven “on the eye” by touching the wall mittens. Of course, this method of verification will be less reliable.
If a TEN malfunction is detected, then the acquisition of a similar part will not be any problems - its exact marking can be found from the manual for the operation of the oven or in directories on the Internet.
Almost always, the repair of the oven consists in the purchase of new parts, since many of them are not subject to repair.